Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Assembly/Reassembly
14. INSTALL REAR SEATBACK BOARD SUB-ASSEMBLY See: Body and Frame/Seats/Service and Repair/Overhaul/Rear Center Seat
Assembly/Reassembly
15. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
16. INSTALL CENTER SEAT CUSHION ASSEMBLY See: Body and Frame/Seats/Service and Repair/Overhaul/Rear Center Seat
Assembly/Reassembly
17. INSTALL REAR SEAT CUSHION HINGE COVER UPPER RH See: Body and Frame/Seats/Service and Repair/Overhaul/Rear Center Seat
Assembly/Reassembly
18. INSTALL REAR SEAT CUSHION HINGE COVER UPPER LH See: Body and Frame/Seats/Service and Repair/Overhaul/Rear Center Seat
Assembly/Reassembly
19. INSTALL REAR CENTER SEAT ASSEMBLY
(a) Install the rear center seat assembly See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Center Seat
Assembly/Installation.
Components
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: COMPONENTS
Removal
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL
HINT
*
Use the same procedure for the LH side and RH side.
*
The procedure listed below is for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
*
After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory