Sequoia 4WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_4wd/v8-4.6l_(1ur-fe)/Page-234006.png)
(b) Remove the 2 screws and leg support adjustment switch.
(c) Disconnect the connector.
14. REMOVE FRONT POWER SEAT SWITCH LH (w/o Memory)
(a) Disconnect the connector.
(b) Remove the 3 screws and front power seat switch.
Installation
SEAT: POWER SEAT SWITCH (for Front Seat): INSTALLATION
HINT
*
Use the same procedure for the LH side and RH side.
*
The procedure listed below is for the LH side.
1. INSTALL FRONT POWER SEAT SWITCH LH (w/o Memory)
(a) Install the front power seat switch with the 3 screws.
(b) Connect the connector.
2. INSTALL LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch)
(a) Connect the connector.