Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Power Seat Switch: Testing and Inspection
Power Seat Switch (for Rear No. 2 Seat)
SEAT: POWER SEAT SWITCH (for Rear No. 2 Seat): INSPECTION
1. INSPECT REAR POWER SEAT SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) If the result is not as specified, replace the switch.
(c) Apply battery voltage to the switch connector, and check that the rear power seat switch illuminates.
OK:
(d) If the result is not as specified, replace the switch.
2. INSPECT FOLD SEAT SWITCH ASSEMBLY (for RH Side)