Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Torque : 11 Nm (107 kgf-cm, 8 ft-lbf)
NOTICE:
*
Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
*
While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
*
After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the
knuckle.
*
Make sure that there is no foreign matter attached to the magnetic rotor.
(b) Connect the front speed sensor connector.
2. INSTALL FRONT WHEEL See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Front Shock Absorber/Installation
3. INSPECT SPEED SENSOR SIGNAL
(a) Check the speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial
Inspection and Diagnostic Overview/Test Mode Procedure.