Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Cruise Control Switch: Service and Repair
Installation
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
(a) Install the switch, as shown in the illustration.
(b) Install the 2 screws.
(c) Connect the connector.
2. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
6. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.