Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Oil Pressure Sender: Service and Repair
Installation
1UR-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION
1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(b) Install the oil pressure sender gauge.
Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTICE:
Do not start the engine within 1 hour after installation.
(c) Connect the sender gauge connector.
2. INSPECT ENGINE OIL LEVEL See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Testing and Inspection
3. INSPECT FOR OIL LEAK See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Engine Oil/Service and Repair/Replacement
4. INSTALL NO. 1 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Engine Oil/Service and
Repair/Replacement