Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Refrigerant Pressure Sensor / Switch: Service and Repair
Installation
HEATING / AIR CONDITIONING: AIR CONDITIONING PRESSURE SENSOR: INSTALLATION
1. INSTALL AIR CONDITIONER PRESSURE SENSOR
(a) Sufficiently apply compressor oil to O-ring and the fitting surface of the pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent
(b) Using a deep socket wrench 27 mm, install the pressure sensor.
Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)
(c) Connect the connector.
2. CHARGE REFRIGERANT See: Heating and Air Conditioning/Service and Repair
3. WARM UP ENGINE See: Heating and Air Conditioning/Service and Repair
4. INSPECT FOR REFRIGERANT LEAK See: Heating and Air Conditioning/Service and Repair