Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Impact Sensor: Service and Repair
Side Airbag Sensor
Components
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: COMPONENTS
Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: REMOVAL
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service
and Repair/Disassembly
3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers) See: Body and Frame/Doors, Hood and
Trunk/Doors/Front Door/Service and Repair/Disassembly
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
5. REMOVE FRONT ARMREST BASE UPPER PANEL See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and