Sequoia 4WD V8-4.6L (1UR-FE) (2010)
NOTICE:
*
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector,
replace it with a new one.
*
When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with other parts and that it is
not pinched between other parts.
*
When replacing the occupant classification ECU, replace the bolt with a new one.
3. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
(a) Install the front seat assembly RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for
Manual Seat)/Installation.
4. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)
(a) Install the front seat assembly RH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for
Power Seat)/Installation.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
6. INSPECT SRS WARNING LIGHT
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System