Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(c) Remove the starter pinion drive lever.
(d) Remove the starter center bearing clutch from the starter yoke.
3. REMOVE STARTER BRUSH HOLDER ASSEMBLY
(a) Remove the 2 screws and end frame.
NOTICE:
While holding down the lead wire, remove the starter commutator end frame.
(b) Disconnect the 4 brushes from the starter brush holder.
(1) Using a screwdriver, hold back the brush holder.
(2) Disconnect the brush from the brush holder.
(c) Remove the brush holder.
4. REMOVE STARTER YOKE ASSEMBLY
(a) Remove the starter yoke from the starter armature.
5. REMOVE STARTER ARMATURE PLATE
(a) Remove the starter armature plate from the starter center bearing clutch.