Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-1847003.png)
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(2) If the result is not as specified, replace the magnet starter switch assembly.
3. INSPECT STARTER ARMATURE ASSEMBLY
(a) Check the appearance.
If the surface is dirty or burnt, restore the surface with sandpaper (No. 400) or on a lathe.
(b) Measure the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(2) If the result is not as specified, replace the starter armature assembly.
(3) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(4) If the result is not as specified, replace the starter armature assembly.
(c) Check the commutator circle runout.
(1) Place the armature shaft on V-blocks.