Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Steering Column Control Module: Service and Repair
Removal
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column): REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
*
After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory
and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the
negative (-) battery terminal.
*
Some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Programming and Relearning.
2. REMOVE UPPER STEERING COLUMN COVER
(a) Remove the 2 screws.
HINT
Turn the steering wheel to the right and left as necessary to remove the 2 screws.
(b) Detach the 4 clips.
(c) Detach the claw to remove the upper steering column cover.
3. REMOVE LOWER STEERING COLUMN COVER
(a) Detach the 2 claws to remove the lower steering column cover.
4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release