Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER (w/ Antenna)
(a) Install the tire pressure warning receiver with the bolt.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Connect the tire pressure warning receiver connector.
2. INSTALL ROOF HEADLINING
See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
3. INSPECT TIRE PRESSURE WARNING SYSTEM
See: Wheels and Tires/Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure