Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Tire Pressure Warning Reset Switch: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RESET SWITCH: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RESET SWITCH
(a) Engage the 2 claws to install the tire pressure warning reset switch.
NOTICE:
Securely engage the 2 claws.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Installation
3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release
Cable/Service and Repair/Installation
4. INSTALL INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
5. INSTALL COWL SIDE TRIM BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
6. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
7. INSPECT TIRE PRESSURE WARNING SYSTEM
See: Wheels and Tires/Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure