Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(a) Coat the lip of a new oil seal with power steering fluid.
(b) Using SST and a press, press in the oil seal.
SST : 09950-60010
09951-00280
SST : 09950-70010
09951-07100
NOTICE:
Make sure that the oil seal is installed facing in the correct direction as shown in the illustration.
2. INSTALL VANE PUMP SHAFT SUB-ASSEMBLY WITH PULLEY
(a) Coat the inside surface of the bushing in the vane pump front housing with power steering fluid.
(b) Gradually insert the vane pump shaft sub-assembly with pulley.
NOTICE:
*
Do not damage the lip of the oil seal in the front housing.
*
Wrap protective tape around the spline of the vane pump shaft with vane pump shaft sub-assembly with pulley in order to prevent
damage to the oil seal.
3. INSTALL VANE PUMP FRONT SIDE PLATE
(a) Coat a new O-ring with power steering fluid and install it into the front housing.
(b) Coat a new O-ring with power steering fluid and install it onto the front side plate.