Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Remove engine assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
(b) for 3UR-FBE:
Remove engine assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
(c) for 1UR-FE:
Remove engine assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
4. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
(a) Put matchmarks on the No. 2 steering intermediate shaft and the power steering gear.
(b) Remove the bolt and disconnect the No. 2 steering intermediate shaft from the power steering gear.
5. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
(a) Remove the cotter pin and nut.
(b) Using SST, disconnect the tie rod end LH from the steering knuckle.
SST : 09610-20012
NOTICE:
*
Hang SST with a string, etc. to prevent it from falling.
*
Do not damage the front disc brake dust cover.
*
Do not damage the ball joint dust cover.
*
Do not damage the steering knuckle.
6. DISCONNECT TIE ROD END SUB-ASSEMBLY RH
HINT
Use the same procedures described for the LH side.
7. DISCONNECT PRESSURE FEED TUBE ASSEMBLY
(a) Using a union nut wrench, disconnect the pressure feed tube (return tube side) from the power steering gear.