Sequoia 4WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_4wd/v8-4.6l_(1ur-fe)/Page-2239002.png)
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)
NOTICE:
*
No further tightening is required once the nut is tightened to the specified torque.
*
Check that there is no foreign matter on the washer and nut.
(d) Set the wheel disc to a mounting machine and install the lower tire bead. At this time, position the main body of the tire pressure warning valve
and transmitter in the shaded area shown in the illustration.
NOTICE:
*
If the tire pressure warning valve and transmitter is positioned outside this area, it interferes with the tire bead, possibly causing
damage to the tire pressure warning valve and transmitter.
*
If the use of lubricant is required when installing the bead, do not apply the lubricant directly to the tire pressure warning valve
and transmitter.
(e) Install the upper bead.
NOTICE:
Make sure that the tire bead and tool do not interfere with the main body of the tire pressure warning valve and transmitter and that
the tire pressure warning valve and transmitter is not clamped by the bead.
(f) Install the valve core to the tire pressure warning valve and transmitter.
(g) Inflate the tire. If the valve nut is loose after inflating the tire, retighten the nut to the specified torque and then check for air leaks with soapy
water.
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)
NOTICE:
Do not tighten the nut further after tightening it to the specified torque.
(h) Adjust the air pressure of the tires to the specified value.
(i) Install the cap to the tire pressure warning valve and transmitter.
2. INSTALL FRONT WHEEL See: Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and Replacement/Front Shock
Absorber/Installation
3. INSTALL REAR WHEEL See: Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and Replacement/Rear Shock
Absorber/Installation
4. INSPECT TIRE See: Testing and Inspection/Component Tests and General Diagnostics
5. REGISTRATION TRANSMITTER ID
See: Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration
6. INITIALIZE SYSTEM
See: Tire Monitoring System/Testing and Inspection/Programming and Relearning/Initialization
7. INSPECT TIRE PRESSURE WARNING SYSTEM