Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Transmission Cooler: Service and Repair
Installation
A760F AUTOMATIC TRANSMISSION / TRANSAXLE: OIL COOLER: INSTALLATION
1. INSTALL OIL COOLER TUBE (w/ Trailer Towing System)
(a) Temporarily install the oil cooler tube to the engine with bolt A. Install bolt B and tighten it to the specified torque. Then tighten bolt A to the
specified torque.
Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)
2. INSTALL NO. 2 OIL COOLER TUBE (w/ Trailer Towing System)
(a) Install the No. 4 oil cooler inlet hose and No. 4 oil cooler outlet hose to the No. 2 oil cooler tube.
NOTICE:
Make sure the paint marks and pinching portion of each clip are facing the directions shown in the illustration.
(b) Install the No. 2 oil cooler tube together with the 2 oil cooler hoses with the bolt.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Connect the No. 4 oil cooler inlet hose and No. 4 oil cooler outlet hose to the cooler condenser.
NOTICE:
*
Make sure the paint marks are facing the directions shown in the illustration.
*
Make sure the pinching portion of each clip is not in the hatched areas shown in the illustration.
3. INSTALL COOLER CONDENSER ASSEMBLY (AIR COOLED OIL COOLER) (w/ Trailer Towing System)
(a) Install the cooler condenser See: Heating and Air Conditioning/Condenser HVAC/Service and Repair/Removal and Replacement/Condenser
(w/o Air Cooled Transmission Oil Cooler)/Installation.
4. INSTALL OIL COOLER ACCESSORY ASSEMBLY (w/ Trailer Towing System)
(a) Install the oil cooler accessory assembly to the oil cooler tube, and then pass the 2 hoses through the No. 1 flexible hose clamp and close the
clamp as shown in the illustration.
(b) Connect the 2 hoses to the No. 2 oil cooler tube.
NOTICE: