Sequoia 4WD V8-4.6L (1UR-FE) (2010)
3. Inspect the front differential support bolt for separation.
Repair Procedure
1. If the differential support bolt is separated perform the five steps below.
NOTE
If there is NO damage to the differential support bolt, this TSB does NOT apply. Continue diagnosis to isolate the cause of the condition.
A. Remove the differential support bolt.
Refer to the Technical Information System (TIS) applicable model and model year Repair Manual:
B. Clean the bracket and surrounding area.
C. Install the NEW differential support bolt.
Refer to TIS applicable model and model year Repair Manual:
Torque: 120 N*m (1224 kgf*cm, 89 ft*lbf)