Sequoia 4WD V8-4.6L (1UR-FE) (2010)
/Page-1544002.png)
2. REMOVE TRANSFER HEAT INSULATOR
(a) Remove the 3 bolts and transfer heat insulator.
3. REMOVE PROPELLER SHAFT ASSEMBLY
(a) Place matchmarks on the propeller shaft flange and differential flange.
(b) Place matchmarks on the propeller shaft flange and transfer flange.
(c) Remove the 8 nuts and then remove the propeller shaft assembly.
Installation
DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD): INSTALLATION
1. INSTALL PROPELLER SHAFT ASSEMBLY
(a) Align the matchmarks on the propeller shaft flange and differential flange.