Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Windshield Washer Spray Nozzle: Testing and Inspection
WIPER / WASHER: WASHER NOZZLE: ON-VEHICLE INSPECTION
1. REMOVE WASHER NOZZLE SUB-ASSEMBLY
(a) Start the engine.
(b) Check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.
Standard:
Washer fluid hits the windshield in the areas shown in the illustration.
(1) Front:
Specification:
(2) If the result is not as specified, replace the washer nozzle.
(3) Rear