Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-1257001.png)
Control Assembly: Service and Repair
Rear Cooler Control Panel
Removal And Installation
REMOVAL
1. REMOVE REAR HEATER CONTROL ASSEMBLY
a. Using a screwdriver, release the 2 claws and pull out the control switch assembly, then disconnect the connector.
HINT: Tape the screwdriver tip before use.
INSTALLATION
Installation is in the reverse order of removal.
Disassembly And Reassembly
DISASSEMBLY
1. REMOVE AIR CONDITIONER AMPLIFIER
a. Remove the 2 screws and heater control switch.
b. Remove the 4 screws, A/C amplifier and PC board.