Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-1173006.png)
3. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY (for Rear Load Leveling Suspension)
a. Using a drill, make a hole on the shaded area of the cylinder, as shown in the illustration to discharge the gas inside.
CAUTION:
^
Be sure to perform the procedure in the order, the high pressure chamber and the low pressure chamber.
^
Wear protective goggles and cover the absorber with a plastic bag or like when boring.
^
The discharged gas is harmless, but be careful of chips which may fly out when drilling.
