Sequoia 4WD V8-4.7L (2UZ-FE) (2006)
/Page-1178003.png)
a. Remove the bolt and disconnect the shock absorber from the axle housing.
Torque: 87 Nm (887 kgf-cm, 64 ft. lbs.)
b. Use the same procedure described above to the other side.
c. While holding the piston rod, remove the nut, 2 retainers, cushion and shock absorber.
Torque: 58 Nm (591 kgf-cm, 43 ft. lbs.)
d. Remove the 2 retainers and cushion from the shock absorber.
4. REMOVE REAR SHOCK ABSORBER ASSEMBLY (for Rear Load Leveling Suspension)
NOTICE: When removing and installing of the shock absorber, perform the procedure with the shock absorber stretched completely. The primary
rod reaction force of the shock absorber is approximately 1,000 N.
a. Remove the bolt and disconnect the shock absorber from the axle housing.
Torque: 87 Nm (887 kgf-cm, 64 ft. lbs.)
b. Use the same procedure described above to the other side.
c. While holding the piston rod, remove the nut, retainer, cushion and shock absorber.
Torque: 58 Nm (591 kgf-cm, 43 ft. lbs.)
d. Remove the retainer and cushion from the shock absorber.