Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
* Warranty application is limited to correction of a problem based upon a customer's specific complaint.
Parts Information
Repair Procedure
1.
Remove the seat cushion cover following the instructions in the FRONT SEAT (Separate Type: Power Adjuster) section of the applicable service
manual.
2.
Apply one piece of 1 mm thick felt tape (80 mm x 40 mm) to the seat cushion frame in the location shown below.
3.
Reassemble the front seat with the new seat cushion cover.
NOTE:
Do not use air tools when installing the seat assembly back into the vehicle.