Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
1. DISCONNECT CONNECTOR
Pull the release bar and disconnect the connector.
2. DISCONNECT BRAKE LINES
Using SST, disconnect the 6 brake lines from the actuator assembly.
SST 09751-36011
Torque:
10 mm nut: 15 Nm (155 kgf-cm, 11 ft. lbs.)
12 mm nut: 37 Nm (375 kgf-cm, 27 ft. lbs.)
HINT:
-
When disconnecting the brake lines, use tags or make a memo to identify the place to reconnect.
-
At the time of installation, connect each brake line to the correct position.
3. REMOVE ACTUATOR ASSEMBLY
Remove the 3 nuts and actuator assembly.
Torque: 11 Nm (112 kgf-cm, 8 ft. lbs.)
INSTALLATION
Installation is in the reverse order of removal.
HINT:
-
After installation, fill the brake reservoir with brake fluid and bleed brake system.
-
Check for leaks.