Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Brake Pad: Service and Repair
Front
Front
REPLACEMENT
1. REMOVE FRONT WHEEL
2. INSPECT PAD LINING THICKNESS
Check the pad thickness and replace pads if not within specification.
Minimum thickness: 1.0 mm (0.039 inch)
3. REMOVE CLIP, 2 PINS AND ANTI-RATTLE SPRING
4. REMOVE 2 PADS WITH 4 ANTI-SQUEAL SHIMS
NOTICE: The anti-rattle spring and clip can be used again provided that they have sufficient rebound, no deformation, cracks or wear, and have
had all rust, dirt and foreign particles cleaned off.