Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
^
09950-40011 (09951-04010, 09952-04010, 09553-04020, 09554-04010, 09955-04031, 09958-04011)
C.
Remove the nut and steering knuckle.
NOTE:
4WD:
Be careful not to damage the oil seal and drive shaft boot.
HINT:
4WD:
When it is difficult to disconnect the drive shaft, tap the tip of the drive shaft with a plastic hammer.
10.
2WD:
REMOVE GREASE CAP
A.
Mount the axle hub in a soft jaw vise.
HINT:
Install nuts on the hub bolts, close the vise until it holds the hub nuts. Do not tighten further.
B.
Using a screwdriver, remove the grease cap.
HINT:
Be careful not to damage the grease cap.
11.
4WD:
REMOVE OIL SEAL (INSIDE)
A.
Mount the axle hub in a soft jaw vise.
HINT:
Install nuts on the hub bolts, close the vise until it holds the hub nuts. Do not tighten further.
B.
Using a screwdriver, remove the oil seal (inside).
12.
2WD:
REMOVE LOCK NUT AND ABS SPEED SENSOR ROTOR
Using a chisel and hammer, loosen the staked part of the lock nut.
NOTE:
Be careful not to damage the bushing.
A.
Using the following SST, remove the lock nut.
^
00002-00909 (09318-12010)
NOTE:
Do NOT use air wrench.
B.
Remove the ABS speed sensor rotor.
NOTE: