Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
a. inspect the SET switch.
1. Push the main switch ON.
2. Drive at a desired speed [40 kph (25 mph) or higher].
3. Press the control switch to the SET/COAST.
4. After releasing the switch, check that the vehicle cruises at the desired speed.
b. inspect the ACCEL switch.
1. Push the main switch ON.
2. Drive at a desired speed [40 kph (25 mph) or higher].
3. Check that the vehicle speed increases while the control switch is turned to RES/ACC, and that the vehicle cruises at the set speed when the
switch is released.
4. Momentarily press the control switch upward in the RES/ACC direction and then immediately release it. Check that the vehicle speed
increases by about 1.5 kph (Tap-up function).
c. inspect the COAST switch.
1. Push the main switch ON.
2. Drive at a desired speed [40 kph (25 mph) or higher].
3. Check that the vehicle speed decreases while the control switch is turned to SET/COAST, and the vehicle cruises at the set speed when the
switch is released.
4. Momentarily press the control switch is turned to SET/COAST, and then immediately release it. Check that the vehicle speed decreases by
about 1.5 kph (Tap-down function).
d. inspect the CANCEL switch.
1. Push the main switch ON.
2. Drive at a desired speed [40 kph (25 mph) or higher].
3. When operating one of the followings, check that the cruise control system is cancelled and that the normal driving mode is reset.
-
Depress the brake pedal
-
Shift to except D position (A/T)
-
Push the main switch OFF
-
Pull the cruise control switch to CANCEL