Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
1. PLACE THERMOSTAT IN WATER INLET HOUSING
a. Install a new gasket to the thermostat.
b. Insert the thermostat into the water inlet housing with the jiggle valve facing straight upward.
HINT: The jiggle valve may be set within 30° of either side of the prescribed position.
2. INSTALL WATER INLET
Install the water inlet with the 3 nuts.
Torque: 19 Nm (195 kgf-cm, 14 ft. lbs.)
3. FILL WITH ENGINE COOLANT
4. START ENGINE AND CHECK FOR COOLANT LEAKS
5. RECHECK ENGINE COOLANT LEVEL