Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Blower Motor: Testing and Inspection
Component Inspection
Blower Motor
INSPECTION
1. REMOVE BLOWER MOTOR
a. Disconnect the connector.
b. Remove the 3 screws and motor.
2. INSPECT BLOWER MOTOR OPERATION
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, then check that the motor operations smoothly.
If operation is not as specified, replace the blower motor.
3. INSTALL BLOWER MOTOR
a. Install the motor with the 3 screws.
b. Connect the connector.
Blower Unit
INSPECTION
INSPECT AIR INLET SERVOMOTOR OPERATION
Refer to Heating and Air Conditioning; Testing and Inspection.
Rear Blower Motor
INSPECTION
1. REMOVE REAR SEAT OUTER BELT FLOOR ANCHORS
2. REMOVE BACK DOOR SCUFF PLATE
3. REMOVE REAR DOOR SCUFF PLATE RH
4. REMOVE REAR WINDOW SIDE GARNISH
5. REMOVE REAR QUARTER TRIM PANEL RH