Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
REMOVE HEATER CONTROL ASSEMBLY
Using a screwdriver, release the 2 claws and pull out the control switch assembly, then disconnect the connector.
HINT: Tape the screwdriver tip before use.
INSTALLATION
Installation is in the reverse order of removal.
Disassembly and Reassembly
DISASSEMBLY
REMOVE A/C AMPLIFIER
a. Remove the 2 screws and heater control switch.
b. Remove the 4 screws and A/C amplifier and PC board.