Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
3. Pull SST slightly and push the release lever, then remove the piping clamp with SST.
4. Remove the piping clamp from SST.
b. Disconnect the both tubes.
NOTE: Do not use tools like screwdriver to remove the tube.
Cap the open fittings immediately to keep moisture or dirt out of the system.
HINT: At the time of reassembly, please refer to the following item.
-
Lubricate 4 new O-rings with compressor oil and install them to the tubes.
-
After connection, check the fitting for claw of the piping clamp.
3. REMOVE CONSOLE UPPER PANEL
4. REMOVE REAR CONSOLE BOX
5. REMOVE FRONT CONSOLE BOX
6. REMOVE GLOVE COMPARTMENT PARTS
7. REMOVE LOWER NO.2 FINISH PANEL
8. REMOVE LOWER LH FINISH PANEL
9. REMOVE LOWER COVER
10. REMOVE NO.4 HEATER TO REGISTER DUCT