Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Receiver Dryer: Service and Repair
REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
HINT: At the time of the installation, please refer to the following item.
Evacuate air from refrigeration system.
Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount:
Single A/C : 750 ± 50 g (26.45 ± 1.76 oz.)
Dual A/C: 1050 ± 50 g (37.03 ± 1.76 oz.)
2. DISCONNECT 2 LIQUID TUBES FROM RECEIVER
Remove the 2 bolts and disconnect the both tubes.
Torque: 5.4 N.m (55 kgf.cm, 48 in..lbf)
NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.
HINT: At the time of the installation, please refer to the following item.
Lubricate 2 new O-rings with compressor oil and install them to the tubes.
3. REMOVE RECEIVER
a. Remove 2 bolts and receiver.
HINT: At the time of the installation, please refer to the following item.
If receiver is replaced, add compressor oil to compressor.
Add 20 cc (0.71 fl.oz.)
Compressor oil: ND-OIL 8 or equivalent
b. Remove the 2 bolts and holder.
INSTALLATION
Installation is in the reverse order of removal.