Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-1763001.png)
Oil Pressure Sender: Testing and Inspection
INSPECT OIL PRESSURE SWITCH CONTINUITY
a. Disconnect the connector from the oil pressure sender.
b. Check that no continuity exists between terminal and ground with the engine stopped.
c. Check that continuity exists between terminal and ground with the engine running.
HINT: Oil pressure should be over 24.5 kPa (0.25 kgf/sq.cm, 3.55 psi).
If operation is not as specified, replace the oil pressure sender.
