Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
2. Remove the 6 screws, the throttle control motor cover, motor assembly and washer.
3. Remove the 3 screws, throttle control motor and wave washer from the throttle control motor cover.
c. Reinstall a new throttle control motor.
1. Insert the wave washer into the throttle control motor cover.
2. Align the pin holes of the throttle control motor with the positioning pins of the throttle control motor cover.
3. Attach the grommet to the throttle control motor cover.
4. Install the throttle control motor with the 3 screws.
Torque: 3.4 N.m (35 kg.cm, 30 in.lb)
5. Apply the grease thinly on the whole surface of the gear teeth.
NOTE: Do not apply the grease other than specified because grease has been already applied to the component to be replaced.