Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Standard accelerator pedal position voltage: 0.35 - 0.85 V
4. AFTER INSTALL THROTTLE BODY, INSPECT SYSTEM OPERATION
INSTALLATION
1. INSTALL THROTTLE BODY
a. Connect the water bypass hose to the manifold thermostat on the throttle body.
b. Install a new gasket and the throttle body with the 2 bolts and 2 nuts.
Torque: 18 N.m (185 kg.cm, 13 ft.lb)
c. Install the ventilation cap.
d. Connect the water bypass hose and PCV hose to the throttle body.
e. Connect the throttle position sensor connector.
f.
Connect the throttle control motor connector.
g. Connect the accelerator pedal position sensor connector.
h. Connect the accelerator pedal position sensor wire to the 2 clamps on wire brackets.
2. CONNECT ACCELERATOR CABLE TO THROTTLE BODY
3. INSTALL INTAKE AIR CONNECTOR
4. FILL WITH ENGINE COOLANT
5. START ENGINE AND CHECK FOR ENGINE COOLANT LEAKS
6. INSTALL THROTTLE BODY COVER