Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
5. REMOVE FRONT CONSOLE BOX
6. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor assembly connectors
NOTE: Disconnect the connectors with the airbag sensor assembly installed.
b. Remove the 4 bolts and airbag sensor assembly
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Install the airbag sensor assembly with 4 bolts.
Torque: 20 N.m (205 kg.cm, 15 ft.lb)
b. Connect the airbag sensor connectors.
NOTE:
-
Connection of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor assembly is installed with the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installing , shake the sensor assembly to check that there is no looseness.
2. INSTALL FRONT CONSOLE BOX ASSEMBLY
3. INSTALL REAR CONSOLE BOX ASSEMBLY
4. INSTALL UPPER CONSOLE PANEL
5. INSTALL SHIFTING HOLE COVER
6. 4WD: INSTALL SHIFTING LEVER KNOB