Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
HINT: The seat belt pretensioner operates simultaneously as the LED of the SST activation switch lights up.
e. Dispose of the front seat outer belt (with seat belt pretensioner).
CAUTION:
-
The front seat outer belt is very hot when the seat belt pretensioner is activated, so leave it alone for at least 30 minutes after activation.
-
Use gloves and safety glasses when handling a front seat outer belt with activated seat belt pretensioner.
-
Always wash your hands with water after completing the operation.
-
Do not apply water, etc. to a front seat outer belt with activated seat belt pretensioner.
1. Remove the disc wheel and SST.
2. Place the front seat outer belt in a vinyl bag, tie the end tightly and dispose of it in the same way as other general parts.
Removal and Installation
REMOVAL
NOTE:
-
If the wiring connector of the supplemental restraint system is disconnected with the ignition switch at ON or ACC, diagnostic trouble codes will
be recorded.
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
1. REMOVE FRONT DOOR SCUFF PLATE
Remove the 4 screws and front door scuff plate.
2. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP