Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Evaporator Temperature Sensor / Switch: Testing and Inspection
THERMISTOR (for Rear A/C)
INSPECTION
1. REMOVE SIDE HEATER COVER
2. REMOVE THERMISTOR
a. Disconnect the connector and connector clamp.
b. Using a screwdriver, pull out the sensor
HINT: Tape the screwdriver tip before use.
c. Release the 2 claws and remove the sensor from bracket plate.
3. INSPECT THERMISTOR
4. INSTALL THERMISTOR
5. INSTALL SIDE HEATER COVER