Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
5. REMOVE GENERATOR
a. Disconnect the generator connector.
b. Remove the cap and nut, and disconnect the generator wire.
c. Disconnect the generator wire clamp from the cord clip on the generator.
d. Remove the bolt, nut and generator.
INSTALLATION
1. INSTALL GENERATOR
a. Install the generator with the bolt and nut.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
b. Connect the generator connector.
c. Connect the generator wire with the nut and rubber.
d. Install the cap.
e. Install the generator wire clamp to the cord clip on the generator.
2. INSTALL PS VANE PUMP PULLEY
3. INSTALL GENERATOR DRIVE BELT
Install the belt by turning the belt tensioner counterclockwise.
HINT: The pulley bolt for the belt tensioner has a left-hand thread.
4. PERFORM ON-VEHICLE INSPECTION
5. INSTALL NO.2 FAN SHROUD
Install the No.2 fan shroud with the 2 clips.