Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
3. REMOVE INTAKE AIR CONNECTOR
4. DISCONNECT THROTTLE BODY ASSEMBLY FROM INTAKE MANIFOLD
5. REMOVE INTAKE MANIFOLD ASSEMBLY
6. REMOVE STARTER
a. Remove the 2 bolts holding the starter to the cylinder block.
b. Disconnect the starter from the cylinder block.
c. Disconnect the starter connector.
d. Remove the nut, bolt and disconnect the starter wire.
e. Remove the bolt, and disconnect the engine wire protector from the starter.
f.
Remove the starter.
INSTALLATION
1. INSTALL STARTER
a. Install the engine wire protector to the starter with the bolt.
Torque: 9.81 N.m (100 kgf.cm, 84 in..lbf)
b. Connect the starter wire with the nut.
Torque: 9.81 N.m (100 kgf.cm, 84 in..lbf)