Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
b. Inspect contact plate for wear.
Using vernier calipers, measure the contact plate for depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
If the depth of wear is greater than the maximum, replace the contact plate.
c. Remove terminal kit parts.
1. Put a wooden block on the plate, and press it down with a hand press.
Dimensions of wooden block: 20 X 33 X 40 mm (0.79 X 1.30 X 1.57 in.)
2. Using SST, loosen the terminal nuts.
SST 0981-38140
3. Terminal C:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate and terminal insulator (inside).
4. Terminal 30:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate, terminal insulator (inside) and
insulation paper.
d. Temporarily install these new terminal 30 kit parts:
1. Contact plate
2. Terminal bolt
3. O-ring
4. Wave washer
5. Terminal nut
e. Temporarily install these new terminal C kit parts: