Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Measuring Point Reference
5. INSPECT TOE-IN
If the toe-in is not within the specified value, adjust the rack ends.
6. ADJUST TOE-IN AND WHEEL ANGLE
a. Remove the 2 clips.
b. Loosen the tie rod end lock nuts.
c. turn the right and left rack ends by an equal amount to adjust the toe-in.
HINT: Try to adjust the toe-in to the center of the specified value.
d. Make sure that the lengths of the right and left rack ends are the same.
Rack end length difference: 1.5 mm (0.059 inch) or less
e. Tighten the tie rod end lock nuts.
Torque: 55 Nm (560 kgf-cm, 41 ft. lbs.)
f.
Place the boots on the seats and install the clips.
HINT: Make sure that the boots are not twisted.
g. Inspect the wheel angle.
Turn the steering wheel fully and measure the turning angle.