Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
2. REMOVE DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner counterclockwise, and remove the drive belt.
3. DISCONNECT 2 VACUUM HOSES
Remove the 2 clips and disconnect the 2 vacuum hoses.
4. DISCONNECT RETURN HOSE
Remove the clip and disconnect the return hose.
5. DISCONNECT PRESSURE FEED TUBE
Remove the union bolt and gasket, disconnect the pressure feed tube.
6. REMOVE PS VANE PUMP ASSEMBLY
Remove the 2 bolts, nut, stud bolt and PS vane pump assembly.
INSTALLATION
1. INSTALL PS VANE PUMP ASSEMBLY
a. Install the PS vane pump assembly with the stud bolt.
Torque: 22 Nm (220 kgf-cm, 16 ft. lbs.)
b. Install the 2 bolt and nut.
Torque: 44 Nm (450 kgf-cm, 33 ft. lbs.)
2. INSTALL PRESSURE FEED TUBE
a. Connect the pressure feed tube.
b. Install a new gasket and the union bolt to the pressure feed tube.
HINT: Make sure the stopper of the pressure feed tube touches the PS vane pump body as shown in the illustration, then torque the union
bolt.
Torque: 46.5 Nm (475 kgf-cm, 34 ft. lbs.)
3. CONNECT RETURN HOSE
Connect the return hose with the clip.
4. CONNECT 2 VACUUM HOSES
Connect the 2 vacuum hoses and install the 2 clips.
5. INSTALL DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner counterclockwise, and install the belt.
6. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
a. Install the air cleaner assembly with air cleaner hose and the 3 bolts.