Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
a. Using a screwdriver with vinyl tape wound around its tip, remove the oil seal.
NOTICE: Be careful not to damage the front housing.
b. Coat a new oil seal lip with power steering fluid.
c. Using Special Service Tool (SST), press in the oil seal.
SST 09950-60010 (09951-00330), 09950-70010 (09951-07100)
NOTICE: Make sure to install the oil seal facing in the correct direction.
REASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. COAT PARTS INDICATED BY ARROWS WITH POWER STEERING FLUID
2. INSTALL VANE PUMP SHAFT WITH VANE PUMP PULLEY
3. INSTALL STRAIGHT PINS
Using a plastic hammer, tap in 2 new pins to the front housing.
NOTICE: Be careful not to damage the pins.
4. INSTALL CAM RING
Install the cam ring with the inscribed mark facing outward.
HINT: Align the holes of the cam ring with the straight pins.
5. INSTALL VANE PUMP ROTOR
a. Install the vane pump rotor with the inscribed mark facing outward.
b. Install a new snap ring to the vane pump shaft.