Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact on the rack.
d. Employ the same manner described above to the other side.
17. INSTALL RIGHT-HAND AND LEFT-HAND RACK BOOTS, CLAMPS AND CLIPS
a. Ensure that the steering rack hole is not clogged with grease.
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.
b. Set a new clamp to the groove of the rack boot.
c. Install the boot.
NOTICE: Be careful not to damage or twist the boot.
d. Using SST, tighten the clamp as shown in the illustration.
SST 09521-24010
e. Install the clip to the rack boot.
f.
Employ the same manner describer above to the other side.
18. INSTALL RIGHT-HAND AND LEFT-HAND TIE ROD ENDS AND LOCK NUTS
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, torque the nut.
Torque: 55 Nm (560 kgf-cm, 41 ft. lbs.)