Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
6. REMOVE COIL SPRING
a. Begin to lower the axle housing.
NOTICE: Be careful not to snap the brake line and parking brake cable.
b. While lowering the axle housing, remove the coil spring, follow spring and insulator.
HINT: At the time of installation, please refer to the following items.
^
Check that the coil spring end is installed correctly.
^
If the coil spring end is not in the correct position, reinstall the coil spring.
INSPECTION
INSPECT SHOCK ABSORBER
Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual operation sounds. If there is any abnormality,
replace the shock absorber with a new one.
DISPOSAL
1. FULLY EXTEND SHOCK ABSORBER ROD
2. DRILL HOLE TO REMOVE GAS FROM CYLINDER
Using a drill, make a hole in the cylinder, as shown in the illustration to discharge the gas inside.
CAUTION: The discharged gas is harmless, but be careful of chips which may fly up when drilling.
REPLACEMENT