Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
1. INSTALL COIL SPRING TO SHOCK ABSORBER
a. Using a spring compressor, compress the coil spring.
NOTICE: Do not compress the coil spring more than necessary.
b. Install the coil spring to the shock absorber.
HINT: Fit the lower end of the coil spring into the gap of the spring seat of the shock absorber.
2. INSTALL SUSPENSION SUPPORT
a. Install the cushion, 2 retainers and suspension support to the piston rod.
b. Temporarily tighten a new suspension support center nut.
c. Position the suspension support as shown in the illustration.
NOTICE: Do not make your position at the top side of the shock absorber.
HINT: Recheck the direction of the suspension support.
d. Torque the suspension center nut.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
INSTALLATION
1. INSTALL SHOCK ABSORBER WITH COIL SPRING
a. Install the upper side of shock absorber to the chassis frame with the 3 nuts.
Torque: 64 Nm (650 kgf-cm, 47 ft. lbs.)
b. Connect the lower side of shock absorber to the lower suspension arm with bolt, washer and nut.
Torque: 135 Nm (1,400 kgf-cm, 100 ft. lbs.)
2. INSTALL FRONT WHEEL
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)