Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
2. REMOVE PARKING LOCK CABLE ASSEMBLY
a. Remove the screw and parking lock cable No. 2.
b. Using a torx socket wrench, remove the 2 screws and parking lock cable No. 1.
c. Remove the spring.
d. Remove the 2 bolts and parking lock cable housing.
3. REMOVE SHIFT LEVER
a. Disconnect the connector.
b. Using a torx socket wrench, remove the torx screw and shift lever.
c. Remove the upper No. 2 steering column cover.
4. REMOVE SHIFT LEVER HOUSING
Using a torx socket wrench, remove the 3 torx screws and shift lever housing.
INSTALLATION
1. INSTALL SHIFT LEVER HOUSING
Using a torx socket wrench, install the shift lever housing with the 3 new screws.
Torque: 12 Nm (120 kgf-cm, 9 ft. lbs.)
2. INSTALL SHIFT LEVER
a. Install the upper No. 2 steering column cover.
b. Using a torx socket wrench, install the shift lever with a new screw.
Torque: 18 Nm (180 kgf-cm, 13 ft. lbs.)
c. Connect the connector.
3. INSTALL PARKING LOCK CABLE NO. 1 AND NO. 2
a. Apply MP grease on the lock pin and internal surface of shift lever housing.
b. Install the spring and parking lock cable No. 1 into the shift lever housing.
NOTICE: Be careful not to bend or twist the cable abnormally.
c. Using a torx socket wrench, install 2 new screws.
Torque: 2.9 Nm (29 kgf-cm, 25 inch lbs.)
d. Wire the cable No. 1 and No. 2.
e. Install the cable housing to steering column assembly with 2 new bolts temporarily.
NOTICE: Be careful not to bend or twist the cable abnormally.